How To Get Evenflo 360 Car Seat Out

How To's

Removing a rotating car seat can feel intimidating at first. The Evenflo 360 is designed to stay firmly installed for safety, which means taking it out requires a few deliberate steps. Learning how to get Evenflo 360 car seat out correctly helps you switch vehicles, deep clean your car, or store the seat without damaging its locking or rotation mechanisms.

This guide explains the proper removal process based on how the seat was installed.

Important Things to Know Before Removing the Seat

Before starting, keep these key points in mind:

The Evenflo 360 seat and base are removed together as one unit
The seat must be locked in a rear-facing or forward-facing travel position
Never attempt removal while the seat is rotated toward the door
Forcing straps or connectors can damage safety components

Taking your time prevents mistakes.

Before You Get the Evenflo 360 Car Seat Out

Preparation makes removal easier.

Before starting:

Park the vehicle on level ground
Remove your child from the seat
Rotate the seat until it clicks into a locked travel position
Loosen the harness completely
Identify whether the seat was installed using LATCH or a seat belt

How To Get Evenflo 360 Car Seat Out (LATCH Installation)

If the seat was installed using LATCH, follow these steps.

Step 1: Locate the LATCH connectors

Find the lower anchor connectors near the base of the seat.

Step 2: Release the LATCH connectors

Press the release buttons on each connector and pull them away from the vehicle’s anchors.

Step 3: Loosen the LATCH straps

Pull the adjustment straps to remove all remaining tension.

Step 4: Lift the seat out

Grip the seat firmly with both hands and lift it straight up and out of the vehicle.

Avoid dragging the base across the seat cushion.

How To Get Evenflo 360 Car Seat Out (Seat Belt Installation)

If the seat was installed with a seat belt, use this method.

Step 1: Unbuckle the seat belt

Locate the buckle and unfasten it completely.

Step 2: Unlock the seat belt

Release the locking mechanism following your vehicle owner’s manual.

Step 3: Remove the belt from the belt path

Carefully slide the belt out of the rear-facing or forward-facing belt path.

Step 4: Lift the seat out

Once the belt is fully removed, lift the entire seat and base out of the vehicle.

Common Issues During Removal

If the seat feels stuck, check for:

LATCH connectors still partially attached
A locked seat belt not fully released
Tension remaining in the installation straps
The seat not locked into a travel position

Never force the seat loose.

What Not to Do When Removing the Evenflo 360

Avoid these mistakes:

Trying to separate the seat from the base
Removing the seat while rotated toward the door
Pulling aggressively on straps or connectors
Using tools to pry parts loose

These actions can compromise safety.

After Removing the Seat

Once the seat is out:

Inspect connectors and belt paths for damage
Confirm the rotation mechanism still locks securely
Store the seat in a dry, temperature-stable location

Contact Evenflo support if anything appears damaged before reinstalling.

Final Thoughts

Learning how to get Evenflo 360 car seat out properly makes vehicle changes and cleaning much easier. These seats are designed for maximum stability, so careful removal protects both the seat and your child.

Unlock everything fully. Lift with both hands. Recheck before reuse.